產品介紹∣SDT340 多功能超音波測漏儀
Search
SDT340 多功能超音波測漏儀

簡介

SDT340

SDT340重新定義了超音波的力量,使之不僅僅是一款超音波測漏儀。配合使用UAS Lite聲波分析監測軟體,以評估重要設備的健康狀況,同時將振動分析、超音波、紅外線測溫、轉速測量等4種主要測量功能合為一體。
應用範圍廣泛,例如:壓力艙及其管道的氣液洩漏檢測、閥門和液壓系統的洩漏檢測、泵氣蝕檢測、空壓機內部洩漏檢測、輸水器密封狀態檢測、電氣設備局部放電巡檢等應用。

我要諮詢

SDT340重新定義了超音波的力量,使之不僅僅是一款超音波測漏儀。配合使用UAS Lite聲波分析監測軟體,以評估重要設備的健康狀況,同時將振動分析、超音波、紅外線測溫、轉速測量等4種主要測量功能合為一體。
應用範圍廣泛,例如:壓力艙及其管道的氣液洩漏檢測、閥門和液壓系統的洩漏檢測、泵氣蝕檢測、空壓機內部洩漏檢測、輸水器密封狀態檢測、電氣設備局部放電巡檢等應用。

  • 3.5英寸的彩色顯示屏可在最黑暗的條件下為您提供清晰的視覺效果。
  • 使用增強信號紀錄時域波形期間,數據紀錄時間可長達10分鐘。
  • 可回顧現場採集趨勢和警報的歷史數據。
  • UAS3的直觀介面允許在“離線”模式下收集數據。
  • 透過螢幕上的時間波形、頻譜,分屏視圖和圖標導航可提高現場工作效率。
  • 通過focUS模式體驗增強的撞擊檢測。 看到別的檢測方式無法檢測到的缺陷。
  • 平移並擴展您的時域波形或頻譜,列出最高值以協助現場診斷。
  • 可使用SDT340的高清藍牙耳機切斷電源線。
測量方式 超音波、震動、紅外線溫度和轉速表 靈敏度 Class I儀器超過ASTM 1002-11要求,使用適當的傳感器做檢測。
雙傳感器輸入 一種用於超音波測量,另一種用於振動。 顯示 全彩TFT 3.5英寸螢幕320×480。
可視區域:寬度48.96毫米(1.93英寸)x高度73.44毫米(2.89英寸)
時間信號和頻譜 螢幕上的時域波形和FFT頻譜。 平移和縮放以進行信號導航。 顯示10個最高值。 藍芽 用於音頻輸出
頻率範圍 20 kHz至100 kHz(超聲波)。 10 Hz至10 kHz(振動) 外殼材質 擠壓鋁,防震橡膠保護
採樣率 FocUS模式採樣率32、64、128、256 kHz 外觀尺寸 長x寬x高221 x 93.5 x 44毫米(8.7 x 3.7 x 1.7英寸)
每次紀錄的信號長度 600秒(32 kHz採樣率)或150秒(128 kHz focUS模式) 重量 720克(25.4盎司),包括電池
數據儲存 4.2 GB,可存儲71分鐘以128 kHz採樣的信號或286分鐘以32 kHz採樣的信號 耳機 有線耳機和無線藍牙耳機。 使用SDT提供的型號時,SDT340符合噪聲暴露健康和安全要求
  • The 3.5"color display gives you a crystal clear view in the darkest conditions.
  • Record time waveform data up to 10 minutes in duration with enhanced signal data.
  • Recall historical data for trending and alarming in-the-field acquisition.
  • The intuitive interface to UAS3 allows for data collection in “off-route” mode.
  • Enhance productivity in the field with on-screen time signal, spectrum, split screen view, and icon navigation.
  • Experience enhanced impact detection with focUS Mode. See defects others simply cannot.
  • Pan and expand your time signal or spectrum and list the highest values to improve in-field diagnosis.
  • Cut the cord with SDT340’s high definition Bluetooth headphones.
SDT340 Features and Technical Specifications
On-board measurements Ultrasound, Vibration, Infrared temperature and Tachometer. Sensitivity Class I instrument exceeding ASTM 1002-11 requirements for gas leak detection using the appropriate sensor.
Dual Sensor Inputs One for ultrasound measurement and one for vibration. Display Full color TFT 3.5” screen 320x480.
Active area: width 48.96 mm (1.93”) x height 73.44 mm (2.89”).
Time signal and spectrum On-screen time waveform and FFT.
Panning and zooming for signal navigation. Display of the 10 highest values.
Bluetooth For audio streaming.
Housing Extruded aluminum, shock proof rubber protections.
Frequency range 5Hz to 100 kHz (ultrasound). 5Hz to 10 kHz (vibration).
Dimensions L x W x H 221 x 93.5 x 44 mm. (8.7 x 3.7 x 1.7 inches)
Sampling rate 32, 64, 128 and 256 kHz oversampling FocUS Mode.
Weight 720 g (25.4 oz), including battery.
Signal length per recording 600 seconds (32 kHz sample rate) or 150 seconds (128 kHz focUS Mode )